CM80i

CM80i

Regular price $0.00 $0.00

Coursemaster CM82i Autopilot 12vdc

Find A Dealer

The CM80i autopilot with intelligent, self-tuning software and rate gyro compass has been developed primarily for smaller powerboats fitted with outboard motors and hydraulic steering 5 – 10 metres in length. It is also suitable for boats fitted with stern drives and inboard motors.

The CM80i does NOT have a rudder feedback – making it even easier to install!

The CM80i breaks new ground in intelligent autopilots. The new features of this system makes it both easier to install and very easy to use. The intelligence built into the system means that there is no need for a rudder transducer and the system adjusts itself to suit the boat speed and sea state. The CM80i’s compact design fits easily into almost any small boat dash and closely matches engine instruments.

Installation can be completed easily and once installed, requires a simple, once only set up procedure which takes less than a minute. The CM80i’s main components are:

  • Control head
  • Junction box
  • Rate Gyro Compass
  • Hydraulic pumpThe CM80i interfaces with GPS, has a heading output for use with radar, and includes a rate gyro compass.

CM80i AUTOPILOT SYSTEM
Environmental: 0 – 50 deg C
Steering System Types: Hydraulic
Power Consumption: Standby: 300mAmps @ 12VDC
Pilot – 2.5amps @ 20% duty cycle using standard hydraulic pump

CM80i CONTROLLER
Display: Backlit LCD dot matrix
Alarms: Off course, watch keeping, system
Dimensions: 95mm x 55mm
Mounting: panel mount, bracket mount
Cable: 4m

CM840 JUNCTION BOX
Input Voltage: 12VDC
Motor Drive: 15Amp cont
Heading Sensor: Rate Gyro compass
Interface: Nmea 0183, 2 x input, 1 x output
Dimensions: 205mm x 140mm x 45mm

CM437 RATE GYRO COMPASS
Accuracy: 2degrees RMS
Roll/Pitch: +/- 35 degrees
Dimensions: 95mm x 55mm
Cable: 8m

HYDRAULIC DRIVE
CMPRO612
Voltage: 12VDC
Type: Reversing
Capacity: 0.6L/min

Brochure

CM80i


ENL DEALERS

Click on 'Search Now' to find your nearest ENL Dealer or contact us
Phone: +64 9 373 5595 | Email: enquiries@enl.co.nz

Search Now